User manual
WINE COOLER WITH COMPRESSOR BUILT-IN | DOLCETTO 33
8
from overheated. Never unplug the appliance by pulling the power cord. Always grip the plug
firmly and pull straight out from the receptacle. Repair or replace immediately all power cords
that have become frayed or otherwise damaged. Do not use a cord that shows cracks or
abrasion damage along its length or at either end. When moving the appliance, be careful not
to damage the power cord.
POWERBAR WITH SURGE PROTECTION (RECOMMENDED)
Most electrical appliances use a series of electric control boards to operate. These boards are
very susceptible to power surges and could be damaged or destroyed.
If the appliance is going to be used in an area or if your city / country is prone to power surges
/ outages; it is suggested that you use a power surge protector for all electrical devices /
appliances you use. The surge protector that you select must have a surge block high enough
to protect the appliance it is connected to. If you have any questions regarding the type and
size of surge protector needed contact a licensed electrician in your area.
EXTENSION CORD
Because of potential safety hazards under certain conditions, it is strongly recommended
that you do not use an extension cord with this appliance. However, if you must use an
extension cord it is absolutely necessary that it be a VED-Listed, 3-wire grounding type
appliance extension cord having a grounding type plug and outlet and that the electrical
rating of the cord be 220-240 volts and at least 10 amperes.
INSTALLING THE HANDLES
This wine cooler includes 1 stainless steel handles. To install the handle please follow the
below instructions:
1. Remove the door gasket where the handle should be installed on the left side of the
door, as shown below. You won't need tool since the gasket can be removed by hand.
You can start with a corner if you can't remove it from the center.
2. Use the two handle screws, lock washer and flat washer included in the bag containing
