User Manual
BUILT-IN GAS STOVE |
LIVORNO 76
12
Hook position for Hook position for Hook position for
H=20mm top H=30mm top H=40mm top
f) In the event that the gas plate is not installed in a built-in oven, a wooden panel
must be inserted for insulation. This panel should be placed at least 20 mm away
from the bottom of the plate.
Important:
When installing the plate in a built-in oven, the oven must be placed in two
strips of wood; In the case of a junction cabinet surface, remember to leave a space of
at least 45 x 560 mm from the back.
When installing a plate in a built-in oven without forced ventilation, be sure to have air
inlets and outlets to properly ventilate the interior of the cabinet.
Gas connection for gas hob
The gas plate must be connected to the gas supply by a registered installer. During
installation, it is essential to install an approved gas tap to isolate the supply of the plate for the
convenience of any subsequent extraction or service. Connect the plate to the gas network or
to the liquid gas, it must be carried out in accordance with the prescribed regulations in force,
and only after checking that it is adaptable to the type of gas to be used. Otherwise, follow the
Summary of Contents for LIVORNO 76
Page 1: ......
