User Manual
BUILT-IN GAS STOVE |
LIVORNO 76
14
Electrical connection for gas hob
Adjust the power cable with a standard plug for the demand rate indicated on the nameplate or
connect it directly to the mains. In the latter case, a one-pole switch must be placed between
the board and the mains, with a minimum opening between the 3 mm contacts in accordance
with current safety codes (the switch must not interrupt the connection cable to land). The
power supply cable must be positioned so that it does not reach a temperature greater than 50
℃
than the ambient temperature at any point.
Before the actual connection, make sure that:
The fuse and the electrical system can withstand the load required by the board;
The power supply system is equipped with an efficient ground connection in accordance
with the rules and regulations prescribed by law;
The plug or switch is easily accessible.
Important: the cables in the main cable are colored according to the following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
Since the colors of the wires in the main wire may not correspond to the colored markings that
identify the terminals on your plug, proceed as follows: Connect the green and yellow wire to
the terminal marked "E" or green or green and yellow.
Connect the brown wire to the terminal marked "L" or red.
Connect the blue wire to the terminal marked "N" or black.
Summary of Contents for LIVORNO 76
Page 1: ......
