User Manual
BUILT-IN GAS STOVE |
LIVORNO 90
13
Gas connection for gas hob
The gas plate must be connected to the gas supply by a registered installer. During
installation, it is essential to install an approved gas tap to isolate the supply of the plate for the
convenience of any subsequent extraction or service. Connect the plate to the gas network or
to the liquid gas, it must be carried out in accordance with the prescribed regulations in force,
and only after checking that it is adaptable to the type of gas to be used. Otherwise, follow the
instructions in the paragraph entitled "Adaptation to different types of gas." In the case of the
connection to the liquid gas per tank, use pressure regulators that comply with the current
regulation.
Important
: For safety, for the correct regulation of the use of gas and the long life of the plate,
make sure that the gas pressure conforms to the indications given in table 1 "Burner and
nozzle specifications".
Connection to non-flexible tube (copper or steel)
The connection to the gas source must be made in such a way that it does not create
any tension point in any part of the gas plate.
The board is equipped with an adjustable "L" shaped connector and a gas supply
gasket.
The connector must be removed and the gasket must be replaced.
The gas supply connector to the plate is threaded 1/2 gas cylinder.
Flexible steel tube connection.
The gas supply connector to the countertop is threaded, 1/2 "connector for round gas pipe.
Use only pipes and sealing gaskets that meet current standards. The maximum length of
flexible pipes must not exceed 2000 mm Once the connection has been made, make sure that
the flexible metal tube does not touch any moving parts and does not crush.
Check the seal
Once the plate is installed, make sure all connections are properly sealed, use soapy water to
test, never use flames.
Electric connection
The board is equipped with a three-pole power supply cable that is designed for use with
alternating current. According to the indications on the nameplate located under the
nameplate. The ground wire can be identified by its greenish yellow color.
Summary of Contents for LIVORNO 90
Page 1: ......
