Page 9
For technical questions, please call 1-800-444-3353.
SKU 66965
DO nOt
•
install the Battery Pack (11)
until
aFtER
you complete the following
steps to set up the Drill for use.
Refer to Figure 1 for the location of the
•
parts of the Drill for the following steps.
The Drill is designed to accept up to 3/8”
1.
standard drill bits. Do not use larger drill
bits in this Drill as damage to the gears
and/or motor may result. Always use a
drill bit that is designed for the specific
drilling job.
Center the Direction Selector (13) to
2.
“lock” the trigger mechanism as a safety
measure, so the drill does not turn on
accidentally.
While holding the ring behind the collar
3.
of the chuck with one hand, rotate the
collar of the Chuck (5) counterclockwise,
if needed, and place the desired drill bit
or screw driver bit into the drill between
the Chuck Jaws.
Hand tighten the Chuck Adjusting Knob
4.
clockwise until the bit is held securely
in place, centered between the Chuck
Jaws.
Clutch Cap
Set to 3
Torque Setting
Indicator
Figure 3
5.
Set the desired torque setting by rotating
the Clutch Cap.
to drill holes, turn the torque Clutch
a.
Cap so that the drill icon is lined up
with the torque setting indicator.
the numbered settings from 1 to
b.
5 are for driving screws, bolts and
nuts.
It is recommended that a very low
•
torque setting be used when first
driving a screw, and adjust the
setting as the proper force required is
determined.
The torque setting required depends
•
on the item being driven. In the case of
screws, consider the size, length, and
type of material.
If a pilot hole has been drilled into the
•
material, a lower torque setting will be
required.
In addition to single or double-ended
c.
screwdriver bits, adapters with
hexagonal shafts with matching socket
heads can also be used.
Fix the torque setting low enough to
•
allow a safety margin.
Operating the Drill
Insert the fully charged Battery Pack (11)
1.
into the base of the Drill, making sure
that it clicks into place securely. Be sure
the Battery Pack (11) is securely seated
into the Drill Handle so it does not fall off
during use.
Slide the Direction Selector (13) (which
2.
should initially be centered in the “lock”
position) to the right for drilling/fastening,
or to the left for reversing the operation.
If using the Drill to insert or remove
3.
screws, position the driver tip in the item
to insert or remove.
If drilling a hole, hold the Drill above the
4.
area to drill.
Depress the Trigger Switch (18) to start
5.
the drill.
