Installing Your 100 Series
Installing Your 100 Series
2-23
Running Water Source Line
It’s time to run your water line (tubing) from your water source to where your 100 Series will
be place. For this section, you will require
1. Uncoil and run
A
, from where its connected (to your
water source) to wherever you intend to locate your 100 Series. Make any necessary
adjustments (i.e. drilling holes) as you go.
2. Once you have the water line tubing ran all the way to where your 100 Series will be
placed, measure out a 1 - 2 ft. of additional tubing. You want to ensure you have sufficient
slack to pull the 100 Series away from the wall for maintenance.
3. Cut the tubing using your scissors or knife. Be careful to cut the tubing straight across (at
a 90 degree angle) to avoid leaks.
Diagram 2.4.3
Cut Tubing
4. Now, insert the open end of
A
into one end (doesn’t matter
1/4 in. Quick Connect Shutoff Valve
.
Continue to firmly insert tubing
into opening until it won’t go any further. Then pull tubing backwards (away) from valve,
using medium force, to engage/extend the compression sleeve on the valve, and ensure
the connection is secured.
