4
I
Ⅴ
. OPERATION OF REFRIGERATOR
.
Clean the inside before use.
For first time use (or if the appliance has not been used for a long period of
time), you should adjust the temperature to minimum and have the cabinet
empty running for 2 hours, and then put your wine in it and adjust the
desired temperature.
When the power is connected, cooling system starts to work. The
TEMP-ADJ button is set on certain position, which means that if the
temperature in the wine cooler reaches the point set, Self-control
Temperature System stops cooling system so the temperature in the cabinet
rises gradually.
When the inside temperature rises above the set point, Cooling Self-control
Temperature starts to work again, the cellar enter into cooling circles.
The upper zone temperature is adjusted in the range of 7
℃
—12
℃
in the
cabinet
，
and the lower zone temperature is adjusted in the range of
12
℃
—18
℃
in the cabinet, when you want to change the temperature in the
cabinet, You can push “SET UPPER” and “SET LOWER” to the temperature,
press the setting key again to stop the flashing, the temperature will be set.
The actual temperature inside the wine cellar will be displayed after 3
seconds of the setting around.
You can push the “
°
C/
°
F” button to switch between Celsius and Fahrenheit
or
push the “Lamp” button to control the light inside.
NOTE:
After you setting the temperature, the LED display will return to show the
temperature in the cooler, but it could turn to the point that you have set
gradually.
