www.petsafe.net
7
FR
IT
NL
DE
EN
ES
Operating Instructions
Important:
DO NOT RUN DRY - FOR INDOOR USE ONLY.
Note:
Rinse all fountain parts with warm water
before operating the pet fountain. This will remove
any dust or residue that remain in the system from the
manufacturing process.
1. Carefully remove all the Pet Fountain
components from the packaging and set aside
prior to assembly.
2. As with any electrical device, check the electrical
power cord for any tears or damage before use.
3. Place the Foam Filter around the Pump by inserting
the Pump into the Foam Filter from the top, make
sure the electrical power cord rests on top of the
Foam Filter (
Fig.1
).
4. Take the Bowl and place the Pump inside the
square indention. Make sure the circular opening,
Pump Outflow, on top of the Pump is positioned
in the bottom right corner of the square (
Fig.
2
). The Foam Filter will be slightly compressed
between the Pump and the raised post.
5. Press down on the Pump to engage the suction
cups. Once the Pump is securely in place, feed
the Inline Plug of the electrical power cord over
and through the raised post and out the notch on
the bottom side of the Bowl (
Fig. 3
).
6. Remove the extra slack from the electrical power
cord and insert the Rubber Cap into the raised
post. Make sure the cord channel on the Rubber
Cap is aligned with the electrical power cord,
then insert your finger into the Rubber Cap and
push all the way down (
Fig. 4
).
7. Fold the top of the Rubber Cap over the raised
post to seal off the Bowl (
Fig. 5
).
Electrical
power
cord rests
on top
Fig. 1
Pump
outflow
Fig. 2
Fig. 3
Fig. 4
Cord
channel
Fig. 5
Summary of Contents for AVALON-AU-17
Page 99: ...www petsafe net 99 ...
