www.petsafe.net 11
KO
EN
1. Remove Pump from the Pet Fountain as explained in the “Pet Fountain Disassembly
and Cleaning” section (Step 6).
2. Once the Pump is out of the Pet Fountain, with your thumb and forefinger, gently
squeeze on either side of the Faceplate and pull off. It may be necessary to insert
a fingernail into the seam of the Faceplate to pry it off.
3. Next, you will want to remove the Intake Plate by placing your finger nail under
the small lip located on the narrow side of tear drop shaped Intake Plate and pull
out (
fig. 14
).
4. Once the Intake Plate is removed you can also remove the Impeller (white,
3-bladed propeller) which is held in place magnetically. To remove the Impeller
use a fingernail to get under the plastic blade and lift out (
fig. 15
).
Once the Pump is disassembled you
can clean the parts with warm soapy
water. Use a cotton swab or the
“motor” brush from the Drinkwell
®
Cleaning Kit to get into the Motor cavity
and remove any build-up (
fig. 16
). For
added disinfecting and hard water
removal, clean the Motor with a 20%
white vinegar & 80% water solution. Be
sure to rinse thoroughly with fresh water.
5. Once the parts are clean and dry, you
can reassemble the Pump for use.
a) Replace the Impeller.
b) Replace the Intake Plate.
c) Replace the Faceplate.
Intake Plate
Pull-Tab
fig. 14
fig. 15
fig. 16
Summary of Contents for D360SSKA-RE
Page 30: ...30 www petsafe net ...
Page 31: ...www petsafe net 31 ...
