1) Remove the Pre-filter and Housing from the bowl (See “Fountain
Disassembly and Cleaning”)
2) Gently lift the motor out of its resting place. Suction cups on the bottom
of the motor will hold it in place. A small amount of force may be
necessary.
3) Once the motor is out of the fountain, with your thumb and forefinger,
gently squeeze on either side of the intake plate, and pull off. It may be
necessary to insert a fingernail into the seam of the inlet plate to pry it off.
MOTOR MAINTENANCE
4) Next you will want to remove the stator by placing your finger nail under
the small lip located on the narrow side of tear drop shaped stator and
pull out.
Stator
Pull-Tab
Cleaning the motor is essential to the longevity of the fountain as well as
the cleanliness of the water.
IMPORTANT: Warranty may be voided if the motor is not cleaned.
Motor/Pump
Impeller
Stator
Intake Plate
Flow Control
Knob
Fig. 4a
p. 7
Fig. 4c
Fig. 4b
Fig. 4d
Fig. 4e
www.petfountain.com
