4
DRISTEEM INSULATED TUBE ADDENDUM
DRI-STEEM Corporation
a subsidiary of Research Products Corporation
DriSteem U.S. operations are 9001:2015 certified
www.dristeem.com
U.S. Headquarters:
14949 Technology Drive
Eden Prairie, MN 55344
800-328-4447 or 952-949-2415
952-229-3200 (fax)
Continuous product improvement is a policy of DriSteem; therefore, product features
and specifications are subject to change without notice.
DriSteem, Rapid-sorb, and UItra-sorb are registered trademarks of Research
Products Corporation and are filed for trademark registration in Canada and the
European community.
Product and corporate names used in this document may be trademarks or
registered trademarks. They are used for explanation only without intent to infringe.
© 2016 Research Products Corporation
Form No. IT-IOM-Addendum-M-0316
Part No. 890000-155 Rev B
Caring for the insulating material
• If the insulating material gets torn, repair the tear with our Insulating
Material Repair Kit before dispersing steam or moving air through the air
handler to prevent further damage.
This available kit uses tested and proven PVDF as repair material; do not
use other adhesives or repair methods in place of the kit.
• If the insulating material gets dirty or smudged, gently clean it with
a damp cloth and a solution of soapy water or a diluted non-toxic,
biodegradable cleaner/degreaser.
• Do not clean the insulating material with a pressure washer. The direct
spray could cause damage.
• If using a torch in the vicinity of the dispersion panel, keep the flame
away from the insulating material to avoid damage
• PVDF is inherently resistant to UV light. Indirect, low-intensity UV-C light
from germicidal lamps will not cause the insulating material to degrade.
• Do not tighten mounting clamps or fasteners to any part of the dispersion
tube.
