Instructions for use DSF 130
9
Drive Medical GmbH & Co. KG | As per: 23.04.2020 | Errors and alterations excepted
EN
Assembly
The shower chair is preassembled; only the 4 adjustable
feet need to be assembled (see next section).
Unfold it as shown and lift the seat section upwards.
Swing both side parts forwards and then bring the seat
section down until it rests on the retaining clips (
pic. 1+2
).
1
2
Now push the seat section down firmly until it audibly
clicks into place in the left and right retaining clips (
pic. 3
).
Check the proper position of the seat section in the
retaining clips (
pic. 4
).
3
4
Height adjustment of the feet
Before using the product, ad-
just it to the desired height
(
pic. 5
). To adjust the height of
the legs:
Press button (
1
) and at the
same time, pull the leg out
or push it in until the button
clicks into place in the de-
sired position (
2
). Ensure that
the pushbutton has correctly
clicked into place.
Ensure that all four legs are adjusted to the same height.
Cleaning | Maintenance
• Clean regularly with a moist cloth!
• Do not use any aggressive cleaning agents!
• Do not use abrasive cleaners!
• Do not use any high-dose chlorine and vinegar-based
cleaners!
• To disinfect, a spray disinfectant can be used such as
Descosept AF or Bacillol AF.
• Check the screws regularly and tighten, if necessary.
• The product should not be exposed to temperatures
above 60 °C for long periods of time (for example, use
in a sauna, etc.).
• In the event of defects, contact your specialist dealer
from whom you purchased this product.
Technical data
Product
DSF 130
Article number
550200100
HMV (medical aids
register) no
04.40.03.2021
Overall depth
56 cm - 58 cm
Overall width
53 cm
Overall height
90 - 100 cm
Height of backrest
46 cm - 48 cm
Seat (W/D/H)
41 cm / 41 cm / 52 cm
Seat adjustment settings
5
Weight
3.8 kg
Max. load
130 kg
Frame material
Welded steel tubing,
powder-coated
Seat / armrest
cover material
PP (polypropylene) /
PU (polyurethane)
