16
User Manual Multitec
Drive Medical GmbH & Co. KG | As per: 13.03.2018 | Subject to error and change
EN
Preparing for use
Your multifunction wheelchair is usually delivered
completely assembled. Some simple maneuvers will
make it ready for use.
Risk of pinching!
Watch your fingers when folding and setting up the
wheelchair and access the only the parts shown.
Locking the backrest
Set the backrest upright
and attach the backrest to
the frame base using the
connecting pin. Push the
connecting pin through
the slots and secure the
pin with the locking clip.
Make sure that the pin is
locked securely.
Mounting the back cushion
The supplied back
cushion is attached to the
back plate with a Velcro
connection. Make sure that
the back cushion is flush.
Adjusting the height of the backrest
To adjust the backrest
height, loosen the 4
hexagon socket screws
in the retaining clips and
move the backrest into
the desired position, then
re-tighten screws.
Mounting the seat cushion
The seat cushion delivered
with the wheelchair is
fastened to the seat plate
with Velcro.
Ensure that the seat
cushion lies flush.
Mounting the armrests
Press the locking knob
and push the side parts/
armrests into the brackets
provided for this purpose
until they click into place.
Mounting the leg supports
Mount the leg supports on the brackets on the front
provided for this purpose on the wheelchair. Turn the leg
supports inward.
Ensure that the leg supports are securely in position.
Foot plates
After you have inserted the
leg supports, rotate the
foot plates downward.
The supporting surface
of the foot plates is
telescopic.
Mounting the headrest
Insert the headrest into the provided bracket on the
backrest. To do this, pull the locking knob (Fig. 10) out
and push the headrest all the way down.
5
