18
Instructions for use LITEC 2G PLUS
Drive Medical GmbH & Co. KG | As per: 24.06.2020 | Errors and alterations excepted
EN
Seat depth adjustment
Upon delivery, the seat depth of all models is set at 42
cm. This seat depth can be adjusted in a total of 3 in-
crements up to 47 cm. Before adjusting the seat depth,
open both Velcro fasteners on the seat cushion
(photo
11) and fold the front part of the cushion forwards (photo
12).
11
12
To adjust the seat depth, remove both screws on the
front longitudinal tube on both sides
(photo 13).
13
14
Now you can pull the frame forward to the next hole (a
total of 3 times) and reinsert the screws.
Ensure that all screws are reinserted and tightened!
Fold the front seat cushion back again and refasten the
Velcro fasteners.
Adjusting the backrest and cushion
The degree of firmness of
the backrest can be indi-
vidually and continuously
adjusted using the 5 Vel-
cro straps (loosen or tigh-
ten) (
photo 15).
To attach the back cushion,
place it as shown (
pho-
to 16) on the wheelchair
and fold it over in succes-
sive parts.
Place part 1 on the inside
of the backrest, part 2 on
the back side, and smooth
part 3 from behind under
the seat surface.
The cushion is secured automatically by the integrated
Velcro straps (
photo 17+18).
17
18
Adjusting the height of the backrest
The height of the backrest can be adjusted in increments.
Note: When the backrest is adjusted, the height of the
push handles is also automatically adjusted.
To adjust the backrest,
remove the left and right
nuts under the guide tube
of the backrest (
photo 21).
Pull the screws out. Now
adjust the desired height
by pulling or pushing on
the respective push hand-
le.
