Instructions for use LITEC 2G PLUS
19
Drive Medical GmbH & Co. KG | As per: 24.06.2020 | Errors and alterations excepted
EN
Reinsert the screws, put on the knurled nuts and tighten
them.
Always ensure that both sides are adjusted identically.
Adjusting and removing armrests
The armrests are alrea-
dy assembled on the
wheelchair upon delivery.
The armrest overlays are
replaceable.
The armrest overlay can
be adjusted as a short or
long arm support as nee-
ded
(photo 20).
To adjust, press the spring
button in the middle on
the outside of the armrest
overlay; this can now be
moved into the desired
position
(photo 21).
The height of the armrest overlay can also be adjusted;
to do this, press the spring button in the middle under
the armrest overlay and lift it and/or lower it.
The spring button must
lock back into position af-
ter adjustment. Select the
closest position, if neces-
sary.
To swivel the armrest
backwards, engage the release lever at the front of the
arm rest and hold it down it while simultaneously pulling
the armrest up until the armrest is free. Now it can be
swiveled backwards
(photo 22).
Adjusting and using the parking brake
Upon delivery, the parking brake is correctly adjusted
according to the confi guration status. If you have made
changes to the wheel position, the brake adjustment
may need to be changed.
To do this, remove both screws on the underside of the
respective brake (
photo 23) and push the complete unit
onto the guide such that there is a distance of 10 mm
between the brake bolt and the tire (
photo 24). Retigh-
ten both screws and the parking brake is now optimally
adjusted.
Ensure that all screws are reinserted and tightened!
To use the parking brake, press the brake lever fi rmly
from the front until it noticeably clicks into place – the
parking brake is now engaged (
photo 25).
To release, pull the brake lever towards you and the par-
king brake is unlocked (
photo 26).
Always ensure that the parking brake is locked by att-
empting to move the wheelchair.
25
26
23
24
20
21
22
