12
Instructions for use TRI WALKER
Drive Medical GmbH & Co. KG | As per: 07.07.2020 | Errors and alterations excepted
EN
Height adjustment of push handles
Insert push handles at least to the fi rst cross hole into the
frame tubing. Insert the fi xing screw from the inside and
tighten using the washer and star screw (pic. 5).
To change the height adjustment of the push handles,
loosen the fi xing screw by turning the star screw coun-
terclockwise. Then lock the handle at the desired height,
as described above (pic. 6).
5
6
Adjusting the brakes
If braking is poor or too hard, the brake can be adjusted
either at the brake housing above (pic. 7) or using the
adjusting screw on the Bowden cable below (pic. 8) to
achieve the desired braking eff ect.
7
8
The brake is correctly adjusted when the brake lever as
well as the brake wires are free of play and the wheels
can be rotated without grinding noises when the brake
is released.
Braking | Parking
To brake when walking with the rollator, pull both brake
handles upwards with your hands (pic. 9). Always brake
slowly while applying equal pressure with both hands.
To apply the brakes/park the rollator, press both brake
handles downwards until they audibly click into place
(pic. 10)! To release the brake, pull both brake handles
upwards once again until they are released (brake han-
dles are in the middle position).
9
10
The braking eff ect can be impaired by wear and tear on
the tires. For this reason, regularly check the braking
eff ect.
Folding | Transporting | Stowing
To fold up the rollator, pull
the folding mechanism up-
wards (see Unfolding) and
fold up.
To allow the rollator to
stand up in a stable position
during storage, leave a gap
of approx. 50 mm between
the rear wheels (pic. 11).
Remove accessories, if necessary!
Cleaning | Maintenance
• Clean regularly with a moist cloth!
• Do not use any aggressive cleaning agents!
• Do not use abrasive cleaners!
• Do not use any high-dose chlorine and vinegar-based
cleaners!
• To disinfect, a spray disinfectant can be used such as
Descosept AF or Bacillol AF.
• Check the screws regularly and tighten, if necessary.
• The product should not be exposed to temperatures
above 60° C for long periods of time (for example, use
in a sauna, etc.)!
• In the event of defects, contact your specialist dealer
from whom you purchased this product!
• Check the condition of the tires regularly. They are
„fail-safe“, meaning that you do not have to check air
pressure or fi ll them with air. Always check the tires for
tears or other damage, however.
11
