The Genesis rollator comes with a cane
holder attachment that can be used with
tri-tip or single tip canes (Figure 11). To
install the cane holder base, rotate so that
the “T” shapes line up. Insert the base and
rotate back. The cane holder and clip can
be used on either side of the rollator. To
move the cane holder base, reverse the
installation steps and reattach to the same
location on the other side of the rollator.
Slide the cane holder clip up off its mount
and move to the same location as the cane
holder base.
Using The Universal Cane Holder
Figure 11
Safety Instructions
•
Use only as a walking aid!
•
Use only on even and solid surfaces.
•
Maximum user weight: 300 lbs.
•
Regularly check the screws and fasteners on the Genesis and retighten
if necessary.
•
Use bag only for transport of objects and do not overload. Maximum load: 11 lbs.
•
Do not expose the product to temperatures above 104°F for an extended period
of time, as this can cause the Genesis parts to overheat and burn the user.
•
Please make sure the Rollator is fully opened, seat is down and the folding bar
under seat is locked in the down position.
•
Be sure that both knobs are fully tightened and are at equal heights. Test Rollator
for stability before applying full weight to hand grips.
•
Test the brake lever before operating the Rollator. When wheels are locked, lock
bar on rear wheels should prevent wheels from turning. When locks are released,
the wheels should turn freely.
•
Always lock the brake lever before sitting and do not use seat when unit is on an
incline or uneven ground.
•
Replace tires when significantly worn or damaged.
•
DO NOT MOVE ROLLATOR WHILE SEATED.
This is a walking aid only
•
and is not to be used as a transportation device.
