10
User Manual Litec 2G
Drive Medical GmbH & Co. KG | As per: 30.01.2018 | Subject to error and change
EN
Assembly
Attach wheels and unfold
Attach the wheels by pressing the unlock button in the
middle of the hub and insert the wheel into the designated
socket on the base. Please make sure that the wheels are
properly locked before use, by pulling the wheel towards
you away from the wheelchair. (Picture 1+2).
Unfold the wheelchair by pushing the seat until it locks in
place.
1
2
Mounting footrests
Mount both footrests as shown in and move them to the
inside until you perceive a clear audible snap. Pull the le-
ver upwards and move the footrest to the outside, in order
to release/ remove them. (Picture 3+4).
3
4
Adjusting length and inclination of footrests
ADJUSTING LENGTH (Abb. 5):
Open and remove screw
on the back side of the
footrest with the allen key
and adjust the length to fit
your needs.
Check where the threaded
hole is and install the lo-
cking screw.
Tighten screws!
ADJUSTING INCLINATION (Abb. 6):
Undo the screw on the side
of the footrest (plate) with
an allen key and pull it out
of the gearing.
Then push the plate back
into the gearing after ad-
justing the inclination.
Tighten screws!
Adjusting seat height
The height of the seat can
be adjusted in 3 positions.
Remove both wheels by
pushing the release but-
ton in order to adjust the
height..
Open the nut on the wheel
receiver and move it to the
desired drilling. Install the
nut with the lock washer
and tighten it. (Picture 7).
Make sure the nut is securely tightened!
Adjusting sitting height (front wheels)
The sitting height in the
front can be adjusted in
3 positions as well as the
desired inclination. (Picture
8).
Remove the screw from the
axle in order to adjust.
The plugs in the holes are
easily replaced.
Adjust the height and tighten the screw.
Make sure the axle is securely tightened!
Adjusting forerum of the front wheels
Please loosen the two safety screws in order to adjust the
forerun of the front wheels.
The forerun can be adjusted by turning right or left.
(Pic. 9+10).
Screws after adjustment absolutely firmly tighten and
the check the correct holding!
10
9
