1. Place assembled Bath Bench upside down on
work surfaces shown in Figure 1.
2. Attach back support by sliding mounting tubes
through aluminum extrusion mounts and lock
into place with spring loaded push-pins.
Periodically check assembly for continued
tightness.
NEVER USE BATH SAFETY SEAT IF ANY
LOOSENESS IN THE ASSEMBLY IS NOTICED,
AS PERSONAL INJURY MAY RESULT. SIT.
DO NOT STAND ON THIS SEAT TO AVOID A
POSSIBLE DANGEROUS FALL.
CAUTION:
Maximum weight limitation for this
product not to exceed 500 lbs.
NOTE:
To maintain the beauty of the original
finish, clean with mild soap and rinse with warm
water. Wipe bath seat dry after each use.
READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING
assembly instructions
FIGURE 1
Height Adujustment
Snap Button
Back
Support
Mounting
Tubes
Aluminum
Extrusion Mounts
