1.
Remove contents from box.
2. Lay seat upside down on a flat surface so the 4 leg
receptacles are facing upward.
3. Insert first leg into the leg receptacle by depressing
push pin. When the leg is in place, the brass push
pin will extend out and lock the leg in place
(Figure 1).
4. Repeat Step 3 for the remaining 3 legs.
assembly instructions
adjusting leg height
1.
Before use, adjust height of each
leg to your specific needs, making
sure all legs are at the same height.
When desired height is reached,
lock legs into place by aligning
buttons into proper holes, per
illustration.
2. To be sure legs are locked into
place by pushing down on or by
pulling legs.
1.
Inspect all parts for shipping damage before
assembly. If there is shipping damage - DO
NOT USE. Contact dealer/carrier for further
instructions.
2.
Make certain that the height adjusting snap
buttons fully protrude through the same
respective hole of each leg extension. This
will ensure that the leg extensions are
securely locked in position and an even height
is achieved.
3.
Ensure ALL screws, nuts and/or bolts are
tightened.
4.
Check the rubber tips on the leg extensions
for rips, wear or if they are missing.
Immediately replace any or all if any of these
imperfections exist.
5.
All four leg extensions with rubber tips MUST
touch the floor simultaneously at all times.
6. DO NOT stand on chair.
additional precautions
NOTE: To maintain the beauty of the original finish,
clean with mild soap and rinse with warm water. Wipe
bath seat dry after each use.
figure 1
WEIGHT CAPACITY: 350 LBS.
