Aston Shower Commode (CWC003)
Page 7 of 12
Potty Installation and Removal
The potty is installed and removed
by sliding the potty in to the two
rails mounted to the underneath of
the seat. To install, slide the potty
underneath the seat from the rear
of the chair, ensuring the potty sits
on both rails of the seat. Ensure
nobody is sat on the chair when
installing or removing the potty to
prevent any trapping risk.
Cover the potty with the lid to reduce the risk of spillages and carefully
dispose of the potty contents in a sluice or WC. Do not dispose of in an
open drain or sink as this can cause serious health risks.
The potty can be cleaned and disinfected manually or in an autoclave. It
should be cleaned after each use. Replacement potties are available from
Drive Medical under product code Z33303-16.
Seat Operation and Removal
The seat is a horse shoe shape with removable cover for the aperture.
When used as a shower chair, it is recommended that the aperture cover
is removed to allow better access to the occupant for cleaning. Ensure
weight is not applied directly to the aperture cover as this can fall
through the seat.
The seat clips on and off the frame. To remove the seat for cleaning, first
remove the potty and aperture cover. Then lift up the front for the seat
to release and slide the seat away from the chair. To attach the seat first
locate the seat by sliding the back of the seat in to the frame, then press
down on the whole of the seat until secure.
