PowerStroll Owner’s Handbook
Page 7 of 8
Part Code: Z24002 (Iss 02/13)
Specification
Weight: 7.5kg (without battery)
6.5kg (battery pack)
14kg (total weight)
Max speed: 3mph / 5kph
Max gradient: 6º
Cruising range up to 10 miles (16km)
Weight capacity:
21 stone (115kg) including wheelchair & user
Motor: 12V 100W D.C.
Battery: 12V 20ah Sealed Lead Acid
Charger: 3A 12V output
TroubleShooting
Wheelchair does not move when trigger is pressed.
Possible Solutions:
Check the PowerStroll is switched on.
Check the battery is fully charged.
Check the connection between the battery and
motor is correct.
Check the wheelchair brakes are not applied.
Check the drive wheel is in contact with the
ground.
Wheelchair is difficult to push manually.
Possible Solutions:
Check the wheelchair brakes are not applied.
Remove PowerStroll.
The PowerStroll is too fast / slow.
Try varying the speed with speed dial.
Try recharging the batteries (if too slow).
Check the wheelchair brakes are not applied.
Compatibility with Drive Wheelchairs
The PowerStrolls are compatible with following
Drive wheelchairs:
Budget Steel Wheelchairs
(product codes: CS1142SP and CS1142TS)
Steel Chair Wheelchairs – self propel
(product codes: SSP16, SSP18, SSP18E and SUSP18)
Steel Chair Wheelchairs – transit
(product codes: STS16, STS18, STS18E and SUTS18)
Lightweight Aluminium Wheelchairs
(product codes: LAWC001, LAWC002*, LAWC007,
LAWC008*, LAWC011, LAWC012*)
Standard Aluminium Wheelchairs
(product codes: XSAWCSP18, XSAWCTS18*,
XSAWCSP20 and XSAWCTS20*)
Super Deluxe Wheelchairs
(product codes: XSSDSP16/18/20 & XSTS16/18/20*)
Spirit Wheelchairs (product code: XSES18)
*
The wheelchairs marked with ‘*’ will require
the attendant brake levers and cable
removing from the wheelchair prior to use.
The actual brake unit can still be used as a
parking brake with these parts removed.
The above list is current at time of printing, and the
omission of a Drive wheelchair from this list does not
mean that the PowerStroll is incompatible with it.
For more information please contact your local Drive
Medical dealer.
Compatibility with Other Wheelchairs
The PowerStroll is suitable for most folding wheelchairs:
with a distance between tubing edges
(W)
of
14½5 ” to 20” (37cm – 50cm). This is usually,
but not always, the same as the wheelchair
seat width
a round tubing diameter
(D)
between 7/8” -
1” (22mm – 25mm)
w
D
Please note that you should check with your dealer
and/or the wheelchair manufacturer. Drive Medical
does not accept any responsibility for other
manufacturer’s wheelchairs, and in some
circumstances a risk assessment should be carried
out prior to installation.
