background image

assembly instructions

1.

  Place the seat, cushioned side down, on a flat 

 

surface and assemble a seat hook to each corner  

 

of the seat. Firmly tighten the screws to prevent  

 

the hooks from sliding or turning.

Caution:

 

The “L” shaped hook must be located in the corner 
indicated by the arrow above.

2.

 

Caution: 

Ensure that the seat stops are positioned as shown on 
both seat rails to prevent the seat from sliding forward. 
Each screw and nut should be tight enough to prevent 
the stop from moving without deforming the end of 
the seat rail, which would prevent easy folding of the 
shower commode chair.

3.

  To install the seat, open the chair to its full width  

 

and place the seat on the seat rails by the hooks  

 

with the two “J” hooks on the seat rails with the  

 

front hook located behind the seat stop. Lower the  

 

other side of the seat until it rests on the seat rails.

4.

  To remove the seat, lift the seat rails about 1 inch  

 

to narrow the chair, then lift the seat out of the  

 

chair. The chair can now be folded completely.

Caution: 

The curved edge of the seat must be at the rear of the 
chair. Lift the seat rails about 1 inch, which allows the 
remaining hooks to engage the seat rails, then push 
down on the seat, which will open the chair to it’s full 
width and lock the seat in place.

Caution: 

Make certain that the front hooks are butted against 
the back of the seat stops prevent the seat from sliding 
forward.

Reviews: