set up instructions
1. Remove Safety Roller from carton.
2. Unfold Safety Roller by lifting ring (Fig 2) from left
upright and open frame.
3. Lift handlebar and position over left upright. Make
sure spring button (A) snaps into hole on the
handlebar underside (Fig 1).
figure 1
height adjustments
Recommended handlebar height is at the wrist with
arms fully extended. With your hand placed on the
handgrip, your elbow should be flexed 20° - 30°.
1.
Open both height adjustment knobs (B).
2. Push in spring button (C), one side at a time
and raise or lower uprights to desired height.
3. Tighten knobs.
accessories
Adjustable forearm platforms, variable resistance tabs
on rear wheels, swivel wheel locking brackets, ankle
prompts, trunk support, extended uprights for
additional height, IV pole and oxygen tank holder.
Call an authorized Drive dealer for detailed information
about our accessories.
figure 2
operating safety roller
Make certain that the person for whom the walker is
being fitted is standing as naturally upright on a firm,
flat surface. Also, they should be wearing the same style
shoes that they will be wearing when using the walker,
during activities of daily living. In most cases, the height
of the handles should be set to allow a 30˚ bend at the
elbow when taking hold of the hand grips.
1. Stand with feet
together inside lower
frame. Walker will not
move if weight is place
on handles.
2. To move forward
release enough
weight on handles to
allow walker to be
rolled forward.
3. Reapply weight on
handles to lock the
wheels and step
forward with one foot
into lower frame.
4. Place other foot into
frame to complete one
step. Repeat from
number one to continue
moving.
folding instructions
1. Press spring button on left side of handlebar and
lift handlebar.
2. Drop handlebar into the center of Safety Roller.
3. Swing left upright outward and squeeze into
Z
position until fully folded.
4. Secure uprights by putting the ring over the left
upright and under the spring button.
A
B
C
