assembly
1.
Remove Safety Roller from carton.
2.
Unfold Safety Roller by lifting ring (Fig 2) from left
upright and open frame.
3.
Lift handlebar and position over left upright. Guide
handlebar into cradles (F).
4.
Make sure spring button (A) snaps into hole on the
handlebar underside.
adjustments
Recommended handlebar height is at the wrist with arms fully
extended. With your hand placed on the handgrip, your elbow
should be flexed 20° - 30°.
HEIGHT
1.
Open both height adjustment knobs (B).
2.
Push in spring button (C), one side at a time and
raise or lower uprights to desired height.
3.
Tighten knobs.
WIDTH
1.
Open knob on handlebar (D) and on crossbar (E).
2.
Extend telescoping tubing on handlebar and crossbar to
desired width.
3.
Tighten knobs (D & E).
NOTE: When Safety Roller is fully extended, spring buttons on
the underside of handlebar and crossbar will snap into position.
Press in both spring buttons if narrower width is desired.
folding instructions
1.
Press spring button (A) on left side of handlebar and lift
handlebar.
2.
Hold handlebar in right hand and with left hand, swing
left upright outward and squeeze into Z position until
fully folded.
3.
Drop handlebar over folded Safety Roller.
4.
Secure the uprights by putting the ring over the left
upright and under the spring button.
accessories
Adjustable forearm platforms, seat, variable resistance tabs
on rear wheels, swivel wheel locking brackets, ankle prompts,
trunk support, extended uprights for additional height, IV pole
and oxygen tank holder.
Call an authorized Drive dealer for detailed information about
our accessories.
