This document and the information contained herein, is the exclusive property of Drivecon and represents a non-public, confidential and proprietary trade secret that may not be
reproduced, disclosed to third parties, altered or otherwise employed in any manner whatsoever without the express written consent of Drivecon.
Copyright © (2015) Drivecon. All rights reserved.
(20)
REPLACE
You can replace a registered transmitter with another transmitter without having access to the receiver.
Use the new transmitter that you want to replace the old transmitter with.
1. Make sure that the stop button is pressed.
2. Press button 8. Keep pressed.
3. Twist and pull out the stop button.
4. Release button 8.
Top LED flashes (green).
5. WITHIN 1 MINUTE FROM PULLING OUT THE STOP BUTTON:
Enter the code: 1-2-3-4 (press the buttons 1, 2, 3, 4).
The transmitter LEDs 1- 4 (red) light up. If the code is invalid, the transmitter turns off. If the code is
accepted, the top LED flashes (green). The transmitter LEDs 1-4 (red) starts to flash.
6. WITHIN 1 MINUTE FROM ENTERING THE CODE:
Press button 3.
The top LED lights (green). LED 2 flashes (red).
7. Enter the replacement ID code (a maximum of 11 digits) for the transmitter that you want to replace
by pressing the transmitter buttons. IMPORTANT! When entering the last digit in the code, keep that
button pressed until you have pressed the stop button.
IMPORTANT! The replacement ID code is placed in
the back of the transmitter. Remove the rubber cover.
This label is placed above the battery lid. You will find
the correct replacement ID code in the bottom of the
replacement code label.
8. Transmitter LED 3 lights (red) when one or more digits have been entered. Transmitter LEDs 3 + 4
(red) light when a maximum number of digits (11) have been entered.
9. Press the stop button. You can now release the button.
10. After approx. 10 seconds the transmitter turns off. NOTE! If replacing fails, press the stop button and
start over again.
