Service Manual
rev 5.0 with software Ind1V022
This manual is for inverter rev 5.0 with software Ind1V022.
CAUTION
-
Before starting, read the instructions carefully.
-
Verify all of the connections are in accordance to the drawings.
-
Verify the motor supply is connected correctly, faulty connection will destroy the inverter.
-
Check the device cover is properly installed.
-
High voltages are present in this device. Switch the power off and after the display turns off, wait 5 minutes
before opening the cover.
-
Insulation resistance test with a megger requires special precautions.
-
Do not make any measurements inside the device when it is connected to the main supply.
-
Do not touch the components on the circuit boards. Static voltage discharge may cause damage or destroy the
IC-circuits.
-
Check all ventilation holes are clear and uncovered.
-
Check that hot air coming from the brake resistors does not cause any danger.
-
Do not make any inspections unless the supply has been disconnected by the main switch.
-
It is forbidden to use radiophones or portable phones near this device with the doors open.
-
All the doors and covers must be closed during crane operation.
-
Inverter is not intended to be used on a low-voltage public network, which supplies domestic premises. Radio
frequency interference is expected if used on such a network.
3/58
Drivecon Inc. reserves the right to alter or amend the above information without notice.
Summary of Contents for D2L
Page 59: ......
