11
6.2.- SYSTEMS WITH ONE MASTER TRANSMITTER
RECEIVER 1
RECEIVER 2
F2
F1
F2
ID1
ID1
ID0
F1
F2
F2
ID1
ID0
SLAVE
MASTER
The master transmitter has a three position “1 / 1+2 / 2” selector switch, while the slave
transmitter has a release “R” pushbutton.
When a tandem operation is needed, operator of the master transmitter must require operator
of the slave transmitter to release the slave receiver/crane.The operator of the slave transmitter must
then start his crane and then depress “R” and “Start” pushbuttons simultaneously. The receiver will
then shut down and wait ready to accept transmission from any of the two transmitters. Next, operator
holding the master transmitter must then start his own crane, select the mode he wants to work in, “2”
to work with the slave crane or “1+2” to work in tandem with both cranes, and then press and hold
“Start” pushbutton until the requested receiver/crane powers up. Refer to the previous page for LED
indications
Once tandem or receiver/crane 2 mode operation from the master transmitter is complete,
operator must then select 1 on the
master transmitter and press “start” to validate the
selection. The slave receiver/crane will then shut down and be ready for operation from the
slave transmitter.
