Schließkraftmessgerät FM100BT
Version 1.7
Seite 34/47
Consider the package labelling requirements therefore by putting a label
outside on the package looking like shown in Figure 4: Shipping label. The size
should be min. 120mm x 110mm, on small boxes (where it does not fit on one
side) it can be 105mm x 74mm. It has to be printed in colour.
Please find further information on our website (refer chapter 5.4 “Contact”).
2.3
Operation
2.3.1
Battery
The device has a build-in Lithium-Polymer battery cell. This cell needs to be
charged once every 6 months to prevent total discharging which leads to a
cell defect.
The Lithium-Polymer battery cell has a defined operating temperature of 0 to
45 ° C during charging and -10 to +60 ° C during discharging (refer chapter
1.5 “Technical Specifications”).
Please find the battery cell’s safety notice on the website of our battery
supplier www.dynamis-batterien.de.
2.3.2
Risks
Please use the device with care. Improper handling may cause injuries because
of the following hazards:
There is a hazard of pinching extremities when putting them into the
measurement area (between the movable and the static part) of the
sensor during compression. Avoid the described area during
compression of the sensor at any case.
There is a hazard of injuries when the device is dropped from great
heights.
Do not open the device on your own. Improper opening or
disassembling of the device may cause defects or short circuits which
can lead to severe burn injuries or electrical accidents.
Summary of Contents for FM100BT
