- 21 -
1. Transmitter and LOBIT 100F do not pair.
Power on the LOBIT 100F after the transmitter shows “Bind to Plane”.
Bring the transmitter close to LOBIT 100F during biding. Make sure you do not move
the transmitter sticks or trim during initial power-on.
2. Transmitter LED suddenly goes out.
Replace the AA batteries in the transmitter.
3. Trasmitter display is not showing the setting interface after holding down the Elevator stick
for2 seconds.
The throttle stick needs to be in the fully down position.
4. Gyro is not working well.
( 1 ) Battery voltage is too low.
( 2 ) Pair the LOBIT 100F with the transmitter again.
( 3 ) Land the LOBIT 100F with the throttle stick in the fully down position for 3 seconds and
then take off again.
5. LOBIT 100F won’t perform flips.
( 1 ) Press and hold down the throttle stick for 1 second to enter into flip mode.
Do the flip when the transmitter “beeps”.
( 2 ) Lipo power is too low. Recharge the LOBIT 100F.
6. LOBIT 100F is shaking and making noise.
Check that the motors, canopy, body and propellers are all properly positioned.
< Top View >
< Bottom View >
Troubleshooting
Blue
Blue
Red
Red
Black
Black
White
White
