Recommend
<
>
Example of LED installed
1
2
<
>
2.4Ghz 6ch Receiver
Fix it on position 1 or 2 using double-sided tape.
At least 6 channels are needed.
PWM not supported.
<
>
Lighting effect of dust cover
<
>
VTX installation position (installed inside)
Fix it on position 1 or 2
for easier frequency channel change.
1
2
<
>
How to balance carbon arms
LED Module is optional
M2.5x5mm
M2.5x5mm
By loosening screws a bit,
you can change positions of carbon arms
to adjust the height of them from ground.
Tighten them again when the job is done.
After placing it on flat ground,
you can check and balance the height
of each carbon arm from ground
by pressing arm clamps.
<
>
J4
LED 12V
VCC 5V
- 7 -
