HeatPack Furnace Installation and Operation Manual
36
Appendix 1: Optional thermostat installation
Using a thermostat will help you maintain a constant temperature throughout the house. A
fixed wall mounted 24v thermostat is required.
NOTE
THERMOSTAT MANUFACTURER’S INSTRUCTION ALWAYS OVERRIDES THE
INFORMATION PUBLISHED IN THE FOLLOWING SECTION.
Thermostat location
- Must be installed on an inside wall of the
house;
- Where it will be the least affected by
affected by air currents from a hot air outlet
or cold outside walls;
- Must be installed at a minimum of 55" (140
cm) above the floor.
- Must be installed at a minimum of 15’ (4.57
m) from the furnace and must not receive
radiation from the glass door.
Thermostat wiring – Stand Alone Installation
•
Before
installing
the
thermostat,
disconnect the furnace from the outlet.
•
Use an 18 AWG 2 strand wire.
•
The terminal is located at the back on
the rear right side of the furnace when
facing it. It is marked with the letter “T”.
•
Loosen the two screws in the middle of
the terminal bloc and insert the wires
in the terminals. Tighten the two
screws.
•
Open the thermostat housing and
connect the wires following the
manufacturer's instructions.
Summary of Contents for HeatPack DF00500
