Dromone Multi– Lock Quick Coupler
QMS 22
Dromone Multi– Lock Quick Coupler
Author:EOD
REV: D - JAN2012
10
Approved:MS
2. Press the ’POWER’ button on the in-
cab control panel to the, The visual Led
will pulsate GREEN and activate an audi-
ble buzzer (continuous tone) in the ma-
chine cab (
Figure 5
).
NOTE: If no further action is taken
within 5 seconds the unit will
automatically ‘LOCK OUT’, the
indicators will go out and the green
LED light will return to a constant
green light.
3. Activation of cylinders:
Press the ’CONTROL’ button within 5 sec-
onds from switch on. The status indicator
light will illuminate to a flashing red sig-
nal and the buzzer will also change from
a continuous tone to a pulsating tone.
This indicates that a positive supply is
being sent to the solenoid valve, which in
turn operates the both lock cylinder.
NOTE: After ’CONTROL’ button is
pressed, the system will activate a
warning signal at 55 seconds, and
after 60 seconds the hitch will reset
to a closed position.
4. Manoeuvre the ‘MULTI-LOCK Quick
Coupler’ to line it up with the bucket or
implement to be picked up (
Figure 7
)
5. Lower the
‘MULTI-LOCK Quick Coupler downwards
and slide forward to engage the front
jaw of the ‘MULTI-LOCK Quick Hitch’
over the nearest bucket pin. Rotate the
‘MULTI-LOCK Quick Hitch’ clockwise to
line up the second bucket pin (furthest
from mach.)
Fig 4.
Hitch in transport position
Fig 7.
Manoeuvring
into bucket
Fig 5.
Switching control box on
Fig 6.
Press ’CONTROL’
Button
