Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
If you touch the Settings button, you will see controls to configure the transect lines.
Touch the Settings button again to close these controls.
Zig-zag Heading
The direction of the arrow pointing towards the last transect lines, in
degrees clockwise from North. The transect lines will be perpendicular to this direction.
Transect Spacing
The distance between transect lines. The first transect line will be
generated at half this distance from the edge of the transect region.
Usage
What these transect lines will be used for. Just Flying is for if you just want to
fly the path. Ignition will cause the generated waypoints to be activated for dropping
with Ignis along the transects. Mapping will show additional controls and interface
elements for designing missions where the drone will be taking photos of the area with
a downward-facing camera.
Figure 98: Touch the Generate Waypoints button to generate waypoints that follow the
transects.
Once you are satisfied with the position and orientation of the transect lines, touch the
Generate Waypoints button to generate waypoints that will fly along these transects, as
shown in Figure 98. The first waypoint will be placed to minimize the distance the drone
has to fly to reach it. In Figure 98, the first waypoint is automatically placed at the top of
the first transect line instead of the bottom, because the top is closer to the drone’s current
position.
Last Updated March 12, 2020
Page 115
