Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
Figure 119: O-ring fully seated on needle mount.
Ensure the o-ring is fully seated on the needle mount and in good condition, as shown in
Figure 119.
Figure 120: Needle hole oriented so that it will face downward when inserted in Ignis.
Place the needle and retainer on the needle mount and make sure that the side port
hole of the needle will be oriented downard once installed in IGNIS, as shown in Figure 120.
Incrementally tighten the screws until the retainer is fully seated on the needle mount.
Last Updated March 12, 2020
Page 131
