Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
Figure 22: App when connected to Ignis.
Touch the connection option corresponding to the Ignis’s Bluetooth Address, which is
shown inside the battery compartment or on the back of the Hopper, to begin connecting to
Ignis over Bluetooth. This will open a screen similar to Figure 22. The status will initially
show “Bluetooth Disconnected” while the app is attempting to connect. Once it successfully
connects, which may take up to 10 seconds, the status will change to “Bluetooth Connected”.
Ignis’s status will be displayed once the app begins to receive messages from Ignis.
4.1.16 Ignis Battery Level
Ignis Battery Level
:
Greater Than 7.4V
Verify that the battery voltage is above 7.4V in the app (Figure 22). See Section 1.3 for
more information about the battery and power information.
4.1.17 Injection Amount
Injection Amount
:
Set
Use the “” and “INJECT -” buttons to set the injection amount in milliliters
(ml), the default setting of 0.4 mL works under most conditions. Verify that the status mes-
sage indicates that the injection amount has been set as shown in Figure 22. See Section 1.10
for additional details.
4.1.18 Reservoir and Pumps
Reservoir and Pumps
:
Filled and Purged of Air
Last Updated March 12, 2020
Page 36
