Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
To insert the needle assembly, slide the needle into the hole in Figure 28. You may need
to rotate the needle assembly in order to fully insert the needle.
Figure 29: Locking the needle assembly.
To lock the needle assembly in place, push inward on the black knob labeled “IGNIS” (as
shown in Figure 29), and twist the knob clockwise until it stops, then pull back on the knob
to click it in place. Verify the needle assembly is locked by attempting to twist the knob
counter-clockwise. It should not be able to rotate.
4.1.20 Drone Preflight Inspection
Drone Preflight Inspection
:
Completed
Ensure that the drone’s preflight inspection is complete.
See section 3.2 for the Matrice 600 Pro preflight inspection checklist.
4.1.21 (OPTIONAL) Start Test Ignitions
(OPTIONAL) Start Test Ignitions
:
Injecting and Dropping
WARNING: If ignition spheres are loaded in the hopper, this will cause them to be injected
and poses a fire risk. If performing this step, do so under controlled conditions.
This can be performed with or without ignition spheres. However, if ignition spheres are
loaded, care must be taken as this will cause the ignition spheres to ignite, which poses a
Last Updated March 12, 2020
Page 40
