Ignis Operations Manual (DJI M600 Variant)
Drone Amplified
is recommended to only fly with 400 spheres but it is possible to fit 450 spheres by filling the
Hopper to the top of the carbon fiber sides. With this many spheres, the injection amount
cannot be set above 0.4 mL or the reservoir will run dry before dropping all 450 spheres.
It is important to make sure that the chutes at the bottom of the Hopper are filled with
ignition spheres so that the first injections are not missed due to the lack of spheres. During
the filling process, use the “AGITATE” button on the app to briefly move the agitator in the
hopper with just a few initial spheres, as shown in Figure 22. Once the chutes are full, the
remaining ignition spheres can be quickly added.
4.1.26 Ready for Takeoff
Ready for Takeoff
:
Ready
Ignis is now ready for flight operations. Ensure that the area is clear and abide by all
flight and takeoff recommendations of the drone manufacturer.
4.2 Starting Dropping and Ignitions Checklist
4.2.1 Arm Ignis
Arm Ignis
:
Armed
Move S3 on the control bar into the armed position (up and towards the user).
4.2.2 Check Ignis Status
Check Ignis Status
:
Idle
Check that Ignis’s status indicates it is idle, or a restartable error (see Section 1.8).
4.2.3 Ensure Drop Area Clear and Safe
Ensure Drop Area Clear and Safe
:
Clear and Safe
Ensure that the drone is currently over a safe area to perform ignitions and that the area
is clear.
4.2.4 Press Start Dropping button in App
Press Start Dropping button in App
:
Pressed
Press the Start button in the Drone Amplified Android app to start dropping.
Last Updated March 12, 2020
Page 43
