Ignis Operations Manual
Drone Amplified
drone. Once the app begins to receive messages from Ignis, Ignis’s status will be displayed
on the right, as shown in Figure 7.11.3a. The following is a description of each button:
EMPTY A:
(Ignis 1 only) Completely empties syringe A.
EMPTY B:
(Ignis 1 only) Completely empties syringe B.
FILL A:
(Ignis 1 only) Completely fills syringe A.
FILL B:
(Ignis 1 only) Completely fills syringe B.
BACKWARD A:
(Ignis 2 only) Sucks air from the A side needle into the reservoir.
BACKWARD B:
(Ignis 2 only) Sucks air from the B side needle into the reservoir.
FORWARD A:
(Ignis 2 only) Injects a large amount of liquid from the A side. Use this to
quickly prime the needle with antifreeze from the reservoir.
FORWARD B:
(Ignis 2 only) Injects a large amount of liquid from the B side. Use this to
quickly prime the needle with antifreeze from the reservoir.
PURGE A:
Injects a small amount of liquid from the A side. Use this repeatedly to clear any
last air out of the tubes and needle before taking off.
PURGE B:
Injects a small amount of liquid from the B side. Use this repeatedly to clear
any last air out of the tubes and needle before taking off.
INJECT - :
Decreases the injection amount of A and B by 0.1 mL.
INJECT
+
:
Increases the injection amount of A and B by 0.1 mL.
AGITATE:
Spins the hopper motor for a short period. Use this to make sure ignition
spheres get into the chutes before takeoff.
DROP 2:
Injects and drops 2 ignition spheres. Use this to test dropping while on the
ground.
START:
Starts dropping. Use this to test dropping while on the ground. STOP Stops
dropping.
Last Updated
Page 102
Apr 13, 2022
