Ignis Operations Manual
Drone Amplified
Figure 4.1.16b: App when connected to Ignis
Touch the connection option corresponding to the Ignis’s Bluetooth Address, which is
shown inside the battery compartment or on the back of the Hopper, to begin connecting to
Ignis over Bluetooth. This will open a screen similar to Figure 4.1.16b. The status will
initially show “Bluetooth Disconnected” while the app is attempting to connect. Once it
successfully connects, which may take up to 10 seconds, the status will change to
“Bluetooth Connected”. Ignis’s status will be displayed once the app begins to receive
messages from Ignis.
4.1.17 Ignis Battery Level
Ignis Battery Level:
GREATER THAN 7.4V
Verify that the battery voltage is above 7.4V in the app (Figure 4.1.16b). See
for more information about the battery and power information.
4.1.18 Injection Amount
Injection Amount:
SET
Use the “” and “INJECT -” buttons to set the injection amount in milliliters
(ml), the default setting of 0.4 mL works under most conditions. Verify that the status
message indicates that the injection amount has been set as shown in Figure 4.1.16b. See
for additional details.
Last Updated
Page 44
Apr 13, 2022
