Ignis Operations Manual
Drone Amplified
Restore Factory Settings:
This will cause the camera to restore its factory settings and
restart.
The following settings appear if you are viewing the settings for a thermal camera (e.g.
Zenmuse XT2 IR).
Thermal Display Mode:
This allows you to switch the display between Visible-only,
Thermal- only, Picture-in-picture, or MSX. MSX will display the thermal video feed, but
sharpen edges by using the visible camera.
Thermal Picture-in-picture position:
This allows you to change the position of the ther-
mal video feed in Picture-in-picture display mode.
Thermal Color Palette:
Changes between different color palettes.
Thermal Isotherm:
Enables or disables isotherm color palettes. Isotherm palettes use a
different color scale for temperatures between certain ranges.
Isotherm Lower Temperature:
Pixels below this temperature will use the normal color
gradient of the palette.
Isotherm Middle Temperature:
Pixels between the lower temperature and the middle
temperature will use a second color gradient.
Isotherm Upper Temperature:
Pixels between the middle temperature and the upper
temperature will use a third color gradient. Pixels above this temperature will use a
fourth color gradient.
MSX Visibility:
Adjusts how transparent or opaque the sharpened edges from the MSX
effect appear.
Measurement Mode:
This option allows you to measure the temperature at specific points
in the video feed, and is only supported by radiometric thermal cameras. “Disabled” will
not show any temperature measurement. “Spot Metering” will show the temperature of a
fixed point on the screen. “Area Metering” will show the highest and lowest temperature
points in a region of the screen.
Area Metering Screen Region:
Selects the region of the screen that is processed in the
Area Metering Measurement Mode. You can select the Entire Screen, Left Half, Right
Half, Bottom Half, Middle Ninth, or Center Point.
Last Updated
Page 96
Apr 13, 2022
