Ignis Operations Manual
Drone Amplified
6.2.2 Disarm Ignis
Disarm Ignis:
DISARMED
On the M600 system, move S3 on the control bar into the disarmed position (down and
away from the user). On the Alta X and IF 1200 systems press the C button. This will
automatically cause Ignis to stop dropping.
6.2.3 Fly Over Safe Ignition Area
Fly Over Safe Ignition Area:
OVER SAFE IGNITION AREA
Fly over an area where it is safe for there to be a ground fire to prevent unintended
ignition of other areas.
6.2.4 Trigger Dropper Emergency Ejection
Trigger Dropper Emergency Ejection:
TRIGGERED, EJECTED
On the M600 system, rotate both dials fully clockwise within 2 seconds of each other to
trigger the emergency release as shown in
. On the Alta X and IF 1200 press and
hold the B and C buttons to trigger the emergency release. Or, use the E-Release button in
the App to trigger an emergency release.
This will cause the Dropper to be ejected and dropped from the Hopper, preventing the
spreading of any fire to the Hopper or drone.
6.2.5 Return Drone to Landing Zone and Land
Return Drone to Landing Zone and Land:
LANDED
Return the drone to the landing zone and land. During this process pay particular care to
watch for any other inflight fires.
6.2.6 Perform Post Flight Inspection
Perform Post Flight Inspection:
COMPLETE
Perform the steps in the post flight inspection in
.
Last Updated
Page 50
Apr 13, 2022
