Parachute Manual DRS-M300 v2.3-EN (2022-08-10)
©2022 Drone Rescue Systems GmbH
9/26
5
Installation
Unmount all propellors and detach all batteries and other power supplies before starting the
installation!
Caution:
Mounted propellors may cause injuries or damages.
Caution:
It is mandatory to verify the correct operation with an assembly test right after the
installation! See chapter
for details.
Install the M300 connector
, the rubber strips, and the
to fixate the mounting plate of the
on the front right arm of the UAV with the cable pointing to the UAV center. Place
it as close to the center as possible, so that you can still unlock and fold the arm. The mounting
plate must be in a horizontal position when the arm is unfolded to the flying position or the
banking angle measurement will be faulty during flight which could lead to an unwanted
deployment. Make sure that the rubber strips are between the arm and the clamps, then
tighten all
Caution:
It is necessary to mount the plate as tight as possible to the mechanism, because
otherwise it will scratch on the other arm, when folded (e.g., during transport).
3 Nm
