Drone Sky Hook DSH-DRD1-P3, Installation And Operation Manual

www.droneskyhook.com

Page 

27

 of 

28

Operation 
 

Drone-Sky-Hook Release & Drop Device – Control Modes of the Dual Drop Wheel 

DSH Models:

 Dual Release & Drop / Dual Release & Drop PLUS 

Operation Mode 1 – Drone Rotation 
 

Remote Controller (Mode 2) 

LEFT STICK 

Operation 

 
Quickly Rotate (YAW) the drone two complete turns counter clockwise to drop the first payload. 
 
Quickly Rotate (YAW) the drone again two complete turns counter clockwise to drop the second payload. 
 
To set the drop wheel back to its previous position, Quickly Rotate (YAW) the drone again two complete 
turns counter clockwise. 
 

Operation Mode 2 – Drone Remote Controller C1/C2 Button and/or DJI App 

Note: Use the DJI App to assign C1 or C2 button to Turn On/Off front LEDs 

Remote Controller 

C1 / C2 Button 

Operation 

 
Press C1 or C2 twice in quick succession (while maintaining about 0.5-1 second between each 
press) to drop the first payload. 
 
Press C1 or C2 twice again in quick succession (while maintaining about 0.5-1 second between 
each press) to drop the second payload. 
 
To set the drop wheel back to its previous position, again press C1 or C2 twice in quick 
succession (while maintaining about 0.5-1 second between each press). 
 

DJI App 

Operation 

Settings – Main Controller Settings – Advanced 

Settings 

 
In the App menu switch the drone’s front LEDs ON, then OFF and then back ON or OFF, then 
ON and then OFF. 
(Total of one ON-OFF-ON or OFF-ON-OFF cycle) to simulate the operation of the C1 or C2 
buttons on the drone’s remote controller (see above). 
 
Maintain about 0.5-1 second idle duration between each switch operation. 

Operation Mode 3 – Manual – FUNC button on DSH unit 
 

DSH Release & Drop unit 

Operation 

 
Press twice the device’s FUNC button to simulate the operation of the C1 or C2 buttons on the 
drone’s remote controller (see above). 
 
Maintain about 0.5-1 second idle duration between each operation of the FUNC button. 

IMPORTANT NOTE

: At the end of each operation wait 3 seconds for the execution your command and before the initiation of the next command (False 

Command Avoidance Algorithm (FCAA)).