Operation Mode 2
–
Drone Remote Controller C1/C2 Button and/or DJI App
Note: Use the DJI App to assign C1 or C2 button to Turn On/Off front LEDs
Remote Controller
C1 / C2 Button
Operation
Press C1 or C2 twice in quick succession (while
maintaining about 0.5-1 second between each press) to
drop the payload.
To set the drop wheel back to its previous position, again
press C1 or C2 twice in quick succession (while
maintaining about 0.5-1 second between each press).
DJI App
Operation
Settings – Main Controller Settings –
Advanced Settings
In the App menu switch the drone’s front LEDs ON and
then OFF.
Or OFF and then ON.
(Total of one ON-OFF or OFF-ON cycle) to simulate the
operation of the C1 or C2 buttons on the drone’s remote
controller (see above).
Maintain about 0.5-1 second idle duration between each
switch operation.
Operation Mode 3
– Manual – FUNC button on DSH unit
DSH Release & Drop unit
Operation
Press twice the device’s FUNC button to simulate the
operation of the C1 or C2 buttons on the drone’s remote
controller (see above).
Maintain about 0.5-1 second idle duration between each
operation of the FUNC button.
IMPORTANT NOTE
: At the end of each operation wait 3 seconds for the execution your
command and before the initiation of the next command (False Command Avoidance Algorithm
(FCAA)).
