DOC-0341 Rev E
1 3
© 2019 DROPLET MEASUREMENT TECHNOLOGIES LLC
5.
Check to make sure that the correct COM port is selected by changing the flow (Figure 8) to
900vccm. Save the change, Restart the Program. Enable the Alicat (Figure 8) and then check
the setpo
int on the Alicat display, it should say “.9”. If the setpoint did not change, plug
in
to the other COM port and verify that the Alicat is connected correctly.
6.
Once the COM port is verified, change the flow on the Alicat flow controller section to
“960”.
Be sure to
Save Changes
and
Restart Program
to initiate the update, (Figure 8).
7.
Once the computer has the correct COM port, be sure to switch to “Disable Alicat Control”,
and unplug the power (Figure 9)
Figure 9: Unplugging power to Alicat flow Control
