DOC-0128 Rev F
© 2017 DROPLET MEASUREMENT TECHNOLOGIES
8 4
12.6.1.5
DMT Service Tab: Timing
Figure 58 shows the Timing sub-tab. This tab is used by DMT and should not be modified by the
customer.
12.7
Program Input Files
The
Dual CCN.exe
program requires two input files:
CCN_SS_Settings.ini
and
CCN_Calibration.ini
. The former stores the supersaturation settings for the instrument,
while the latter stores instrument calibration and configuration information.
Both of these files are in the
C:\
directory, but they should not be modified directly. Instead, use
the program
SS Settings Config Editor.exe
to modify
CCN_SS_Settings.ini
and
CCN
Calibration Editor.exe
to modify
CCN_Calibration.ini
.
Figure 58: DMT Service Tab – Timing Sub-Tab
