WJ-8611 DIGITAL VHF/UHF RECEIVER
LOCAL OPERATION
3-31
F1-F2 AND F1-F2 W/LK SCAN
SETUP
PROCEDURE
For F1-F2 and F1-F2 W/LK (With Lockouts) operations, the Setup menu
selects the actual start and stop frequencies that define the frequency
spectrum that is to be scanned. These menus also select the dwell timer
settings that are to be used in the scan. The setup for F1-F2 and F1-F2
W/LK scans are identical. The only difference between these scan modes
is that the latter mode utilizes the lockout frequencies stored in the Lockout
memory. The setup procedure for an F1-F2 type scan operation is
performed as follows:
1.
Press the SETUP key to enter into the Setup mode and display the
SCAN SETUP menu in the Parameter display. If the display does
not initialize with one of the scan types displayed, continue pressing
the SETUP key until the second line of the menu displays one of the
three scan types (CHANNEL, F1->F2, or F1->F2 W/LK). Rotate
the EDIT knob to select F1->F2 or F1->F2 W/LK in the scan type
menu.
2.
Press the SETUP key to select the F1 display. This is the start
frequency that will be used in the F1->F2 scan sequence.
3.
The F1 display determines the frequency where the F1-F2 scan
begins its search. The frequency range is from 0.00000 to
1000.00000 MHz, with a 10 Hz resolution. When programming the
start and stop frequencies, the F1 frequency must be less than the F2
frequency that will be entered in the next step. From the numeric
keypad, enter the frequency (in MHz) where the scan is to begin.
Terminate the entry by pressing the SETUP key. When the setup
key is pressed, the entry is momentarily displayed in the menu, and
the display increments to the F2 selection.
4.
The F2 display determines the frequency where the F1-F2 scan ends
its search. The frequency range is from 0.00000 to 1000.00000
MHz, with a 10 Hz resolution. When programming the stop
frequency, the F2 frequency must be greater than the F1 frequency
entered in the previous step. From the numeric keypad, enter the
frequency (in MHz) where the scan is to end. Terminate the entry
by pressing the SETUP key. When the setup key is pressed, the
entry is momentarily displayed in the menu, and the display
increments to the STEP selection.
5.
The STEP display determines the size of the scan frequency
increments taken during the F1->F2 and F1->F2 W/LK type scans.
The desired step size range is from .01 to 100.00 kHz, with a 10 Hz
resolution. When entering this parameter, it is important that the
selected size is not greater than the IF bandwidth that is to be used in
the scan operation. Otherwise, gaps in the frequency coverage will
result. Typically, step sizes of approximately 1/2 of the selected IF
Courtesy of http://BlackRadios.terryo.org
Summary of Contents for WJ-8611
