Dru Metro 200XT Installation Manual Download

Page: 14 / 44

English

I N STA LLAT IO N M AN UAL

5.14 Placing the wood, pebble and broken glass sets

The appliance is supplied with a wood, pebble or broken glass set.
The vermiculite that is used to fill the burner is black in case of the wood and broken glass sets. In the case of
the pebble set, the vermiculite has a natural colour.

!Caution

The figures do not always show the correct colours.

!Caution

Strictly observe the following instructions to prevent unsafe situations.

Only use the supplied wood, pebble or broken glass set.

Only use the glow material (see appendix 3, fig. 15) in combination with the wood set.

Place the wood, pebble or broken glass set exactly as described.

!Caution

Placement of the pebble set and broken glass set requires exactly the same actions. The figures only show
the pebble set.

Make sure the ionization and ignition electrodes and the surrounding space remain free
(see appendix 3, fig. 9 to 12).

Make sure that the slot between the burner and the vermiculite tray is kept free.

Make sure there is no vermiculite dust on the burner.

5.14.1 Wood set

The wood set consists of vermiculite (see appendix 3, fig. 13), chips (see appendix 3, fig. 14), glow material (see
appendix 3, fig. 15), ash (see appendix 3, fig. 16), a vermiculite plate consisting of 4 sections (see appendix 3, fig
18a) and a number of logs (see appendix 3, fig. 17).

!Caution

Colours may differ from photograph.

Place the vermiculite plate (consisting of 4 sections) in the appliance, as indicated (see appendix 3, fig. 18b). Plate
numbers 1, 2, 3 and 4 are intended for the Metro 200XT FRONT and plate numbers 1, 2, 5 and 6 for the Metro
200XT TUNNEL.

Fill the burner with vermiculite; evenly spread the vermiculite (see appendix 3, fig. 18).
The vermiculite may not get higher than the edge of the burner.

!Tip

You can influence the flame picture by moving the vermiculite,

!Caution

The burner deck has to remain covered with vermiculite in order to prevent reduction of the burner's life span.

Identify logs A to L (see appendix 3, fig. 17).

!Tip

Use the burn stains on the logs for identification.

Place logs A to L. Use the position brackets for this (see appendix 3, fig. 19 to 27).

!Caution

The logs may not completely cover the burner pattern, as:
•

The main burner will not ignite properly;

•

this may lead to unsafe situations;

•

the appliance will become filthy more quickly, as a result of soot;

•

the flame image will be affected.

Fill the vermiculite tray with chips; spread the chips evenly (see appendix 3, fig. 27).

If required, spread the glow material over the burner.

!Caution

The areas around the ionization and ignition should remain free from glow material. The glow material can also
affect the flame image.

!Tip

•

Fasten the glow material under the chips and/or wood set.

•

It is possible to remove the 2 racks below the pane frame. These are intended for the pebble set, but may
remain in order to place chips in the panel frame as well (see appendix 3, fig. 28). If you wish to remove them,
loosen the nuts (W) and remove the racks (V).