Maintenance
8-7
Gear Box
Maintenance & Operation
•
Do not operate the unit without making sure it contains the correct amount of oil. Do
not overfill with oil or injury to personnel, unit or other equipment may result.
•
For proper operation in subzero conditions, it is mandatory that the following oil be
used:
Spartan EP 320 Industrial Gear Oil
...any other gear oil will void warranty!
Oil Filling Procedure
•
Remove Fill (#1) and Breather Plug (#2).
•
Clean threads on the removed plugs and the plug
holes with degreaser.
•
Fill gear box with the recommended lubricant (see
above) to a level near the center line of the
uppermost horizontal shaft or until lubricant comes
out of the oil level plug hole.
•
Install plugs secure in gear case.
Break-In Period
After the first 100 hours of operation, drain out initial oil, flush
out the gear case with an approved non-flammable, non-toxic solvent such as Whitmore’s
Flushing Oil (#06802030) or Medallion Flushing Oil Kosher (#06812010), and refill.
Thereafter, oil should be changed at least every 2500 operating hours or every 6 months.
Whichever occurs first.
Note: Oil should be changed with greater frequency if unit is used in severe
environments (dust or humidity).
Figure 52- Gear Box
Summary of Contents for 600 GTS Series
